5%
Semi Automatic Laboratory Piezoelectric Sensor Power Supply, 3 Part

Semi Automatic Laboratory Piezoelectric Sensor Power Supply, 3 Part

In Stock

Original price was: ₦708,849.00.Current price is: ₦677,344.60.

  • The Type 5118B is a single-channel Piezotron (IEPE) coupler that provides the constant current excitation required by low impedance, voltage mode sensors with built-in electronics (Piezotron (IEPE) sensors). Sensor power is supplied by the same two-wire cable that provides the low impedance output signal. The Type 5118B decouples the DC bias voltage from the output signal and provides a 2 mA constant current source. Bias indicators display the condition of the sensor and cable (ok, short circuit, interruption). Amplifier gains of 1x, 10x and 100x are selectable from a front panel switch. High-pass filter cut-off frequencies (–3 dB) 0.006 and 0.03 Hz are also selectable by a switch on the front panel. Plug-in type low-pass filters are available to limit the frequency response of the amplifier. These low-pass filters can be used to attenuate unwanted frequency and/or to improve signal-to-noise ratio. The Type 5118B Piezotron (IEPE) coupler transmits an audible low battery warning with an intermit tent chirping sound. Battery life lasts approximately 12 hours at a sensor current of 2 mA. Coupler power can be provided from three sources: four AA 1.5 V batteries, AC-operated from a power line adaptor, or a regulated DC source from 6 to 28 VDC.
Categories: , , , ,

Description

Automation Semi Automatic
Transducer Type Power Transducer
Type Constant Voltage Power Supply
Differential Type 3 Part
Number Of Chambers 2
Brand Kistler
Power 200 W
Voltage 220 V
Usage/Application Laboratory
Part Number 5118B2
Frequency 50 Hz

Reviews

There are no reviews yet.

Be the first to review “Semi Automatic Laboratory Piezoelectric Sensor Power Supply, 3 Part”

Your email address will not be published. Required fields are marked *